User manual

Chapter 2 - Managing a Single Device/Cell Unit Control Page
AlvariCRAFT Device Manager 170 User Manual
Security Page Authentication Algorithm
Data Encryption Option
Security Mode
Default Key (SU/RB)
Default Multicast Key (AU/BU)
Key # 1 to Key # 4
Performance Parameters Page Adaptive Modulation Decision Thresholds
Bridging Page VLAN Tab Management VLAN ID
VLAN Q in Q Ethertype (AU and SU)
Service Provider VLAN ID (SU)
Bridging Page Allow/Deny MAC Address
List Tab (AU)
Table Action Mode
All MAC Addresses in Table
Service Parameters Page DRAP Tab
(AU)
All DRAP Parameters
Service Parameters Page WLP Tab
(AU and BU-B100)
All Wireless Link Prioritization Parameters
Service Parameters Page Traffic Priority
Tab
Low Priority Traffic Min (%)
NOTE
The FTP parameters (FTP Server IP address, FTP Gateway IP address, FTP User Name and FTP
Password), that are available for configuration only via Telnet, are not set to their default values
after Set Partial Operator Defaults. However, they are set to their default value after Set Partial
Factory Defaults. Note that in this case they are set to the default values immediately upon applying
the Set Partial Factory Default option (even before the next reset)..