User manual

Chapter 2 - Managing a Single Device/Cell Unit Control Page
AlvariCRAFT Device Manager 168 User Manual
LEDs are disabled) and all these thresholds are reached, instead of having only
LEDs 2, 5 and 6 light up, all the SNR LEDs will light up.
2.26.4 Parameters Not Changed After Set Complete
Factory/Operator Default Configuration
2.26.5 Parameters Not Changed After Set Partial
Factory/Operator Default Configuration
Page Parameter
Network Management Parameters SNMP Read Community
SNMP Read/Write Community
Installer Password
Device Page General Tab Ethernet Negotiation Mode
Air Interface Page General Tab Antenna Gain
Air Interface Page Frequency Tab Defined Frequency (AU/BU)
Frequency Definition Table (AU/BU)
DFS Required By Regulations (AU/BU)
Air Interface Page Country Code
Parameters
Sub Band Select
Country Code Select
NOTE
The FTP parameters (FTP Server IP address, FTP Gateway IP address, FTP User Name and FTP
Password), that are available for configuration only via Telnet, are not set to their default values
after Set Complete Operator Defaults. However, they are set to their default value after Set
Complete Factory Defaults. Note that in this case they are set to the default values immediately
upon applying the Set Complete Factory Default option (even before the next reset)..
Page Parameter
Network Management Parameters SNMP Read Community
SNMP Read/Write Community
Installer Password
Wi
2
AP Client IP Address (SU/RB)
Device Page General Tab Ethernet Negotiation Mode