User manual

Chapter 2 - Managing a Single Device/Cell Unit Control Page
AlvariCRAFT Device Manager 166 User Manual
2.26.3 Configuration Control
2.26.3.1 LED Operation Mode (SU, BU and RB)
The LED Operation Mode option controls the SNR bar and LED indicators’
behavior. By default, the LEDs indicate the SNR level, which facilitates SU
antenna’s alignment. However, it is also possible to customize the SNR bar to
indicate when specific thresholds for RSSI, SNR, CRC percentage and average
modulation are reached. You can switch between two operation modes:
Default Configuration The Default Configuration parameter enables reverting the system
parameters to a predefined set of defaults. There are two sets of
default configurations:
 Factory Defaults: This is the standard default configuration.
 Operator Defaults: As defined by the administrator (see below).
For each Defaults type, you can choose to set either Partial or Full
Defaults.
 Full Defaults set default values to all parameters excluding a few
parameters listed in
Section 2.26.4

Partial Defaults set default values to all parameters excluding the
parameters that are required to maintain connectivity and
management access to the unit. The parameters that do not
change after Set Partial Factory Defaults are listed in
Section 2.26.5.
The actual change of settings will take place after the next reset.
The following options are available:
 No Default Setting Required
 Complete Factory
 Partial Factory
 Complete Operator
 Partial Operator
 Cancel Pending Request: To cancel a previous Default
Configuration change request that were not applied yet.
Save Current
Configuration As
Operator Defaults
Click on the
Save button to save the current configuration of the unit
as the Operator Defaults configuration The default Operator Defaults
configuration is the Factory Defaults configuration..