User manual

Chapter 2 - Managing a Single Device/Cell Network Management Parameters Page
AlvariCRAFT Device Manager 159 User Manual
SNMP Read Community The SNMP Read Community of the unit. This serves also as the User
Password in Telnet.
Valid values: A string of up to 8 printable characters.
SNMP Read/Write
Community
The SNMP Read/Write Community of the unit. This serves also as
the Administrator Password in Telnet.
Valid values: A string of up to 8 printable characters.
Installer Password The Installer Password in Telnet.
Valid values: A string of up to 8 printable characters.
Enable Filtering On This option enables or disables the IP address based management
filtering. If management filtering is enabled, the unit can only be
managed by stations with IP addresses matching one of the entries in
either the Addresses Ranges or IP Addresses tables, and that are
connected to the unit via the defined port(s). The following options are
available:
 Disable: No IP address based filtering is configured.
 Ethernet Port: Applicable only if the Access to Network
Management parameter is configured to either From Ethernet
Only or From Both Ethernet and Wireless Link. The unit can be
managed from the Ethernet port only by stations with IP
addresses matching one of the entries in the tables. If the Access
to Network Management parameter is configured to From Both
Ethernet and Wireless Link then no IP address based filtering is
configured for the wireless port.
 Wireless Port: Applicable only if the Access to Network
Management parameter is configured to either From Wireless
Link Only or From Both Ethernet and Wireless Link. The unit can
be managed from the wireless port only by stations with IP
addresses matching one of the entries in tables. If the Access to
Network Management parameter is configured to From Both
Ethernet and Wireless Link then no IP address based filtering is
configured for the Ethernet port.
 Both Ethernet and Wireless Ports: Applicable to all options of the
Access to Network Management parameter. The unit can be
managed from the port(s) defined by the Access to Network
Management parameter only by stations with IP addresses
matching one of the entries in the tables.
Wi
2
AP Client IP Address Applicable only for SU and RB. The IP address of a WiFi AP
connected to the SU. The address 0.0.0.0 means none.