User manual

Chapter 2 - Managing a Single Device/Cell Service Parameters Page
AlvariCRAFT Device Manager 137 User Manual
2.20.4.2 AU Burst Parameters/BU Burst Parameters
2.20.4.3 SU Burst Parameters/RB Burst Parameters
Low Priority HW Retries This parameter defines the maximum number of times that an
unacknowledged low priority unicast packet can be retransmitted.
This is the value that will be used by the AU/BU and by the SUs/RB
served with it.
The range is from 1 to 14 times.
High Priority Burst
Interval
This parameterdefines the maximum duration of a burst that can be
made by the AU/BU for high priority packets.
The range is from 0.25 to 10 milliseconds in steps of 0.25
milliseconds, or 0 to disable bursts for high priority packets.
Low Priority Burst
Interval
This parameterdefines the maximum duration of a burst that can be
made by the AU/BU for low priority packets.
The range is from 0.25 to 10 milliseconds in steps of 0.25
milliseconds, or 0 to disable bursts for high priority packets.
High Priority Burst
Interval
This parameterdefines the maximum duration of a burst that can be
made by an SU/RB for high priority packets.
The range is from 0.25 to 10 milliseconds in steps of 0.25
milliseconds, or 0 to disable bursts for high priority packets.
Low Priority Burst
Interval
This parameterdefines the maximum duration of a burst that can be
made by an SU/RB for low priority packets.
The range is from 0.25 to 10 milliseconds in steps of 0.25
milliseconds, or 0 to disable bursts for high priority packets.