User manual
Chapter 2 - Managing a Single Device/Cell Service Parameters Page
AlvariCRAFT Device Manager 132 User Manual
2.20.2.3 IP Range Option
The IP Range Option allows prioritization based on the frame’s source and/or
destination IP address. Frames with matching IPs are allocated to the High
Priority queue, while the rest of the frames are allocated to the Low Priority queue.
UDP/TCP Port Ranges
Tables
Each table can include up to 64 entries.
To add a range to the list, click on the Add button: a new line is
added to the table, colored light blue. Enter the start and end port
numbers in the applicable cells (to enter a discrete port number, enter
it a a Range Start). To add another range, repeat the process. The
color of previously entered addresses will turn green. If you regret,
select the relevant entries and click on the
Revert button.
To remove one or more ranges from the list, select the relevant
entries and click on the
Delete button. The color of the entries to be
deleted will change to red. If you regret, select the relevant entries
and click on the
Revert button.
To change an entry, select the necessary cell(s) and edit its contents.
To delete all entries, check the Delete All Port Range checkbox.
Actual changes in the device will take place only after clicking on the
Apply button.
IP Range Option This option sets up the type of IP prioritization employed:
Disable: The IP prioritization is disabled.
IP Source: Frames with matching source IP addresses will be
allocated to the High Priority queue.
IP Destination: Frames with matching destination IP
addresses will be allocated to the High Priority queue.
IP Source or Destination: Frames with either source or
destination IP addresses within the IP range will be allocated to
the High Priority queue.
IP Address This option defines the base IP address which, in conjunction with the
range mask, defines the IP range used for prioritization.
The default value is 0.0.0.0.
IP Mask This option defines the range mask which, in conjunction with the
base IP address, defines the IP range used for prioritization.
The default value is 255.0.0.0.