User manual

Chapter 2 - Managing a Single Device/Cell Bridging Page
AlvariCRAFT Device Manager 113 User Manual
Operands (Inside
Extended Access Table -
SU only)
Defines the actual value(s) of the parameters defined in the Rule Id
and Op Type columns. Depending on the type of parameter, the
following rules apply:
 MAC addresses - The following types of inputs are supported:
Value, Range, Mask
MAC addresses must be typed in hexadecimal format. All
symbols must be adjacent to each other. No separators are
allowed inside the address representation.
The default setting is 00-00-00-00-00-00.
 IP addresses - The following types of inputs are supported:
Value, Range, Mask
The default setting is 0.0.0.0.
 Port numbers - The following types of inputs are supported:
Value, Range, Enumeration
The default setting is 0.
 IP protocols - The following types of inputs are supported:
Value, Enumeration
Each IP protocol is indicated by its protocol number assigned in
accordance with the IANA Allocation Guidelines for the Protocol Field
(RFC 5237)
Relaying Support Applicable only for AU. The VLAN Relaying Support feature is
applicable only for Trunk Links and Service Provider Links. If the Link
Type is defined as either a Trunk Link or a Service Provider Link and
the VLAN Relaying Support option is enabled, a frame relayed from
the wireless link, which is a frame received from the wireless link that
should be transmitted back through the wireless link, with a VLAN ID
(or a Service Provider VLAN ID) that is not included in the unit's VLAN
Relaying Table, is discarded. If VLAN Forwarding Support is also
enabled, it is necessary to configure all the VLAN IDs in the Relaying
Table also in the Forwarding Table to enable the relaying operation.
Relaying Table Applicable only for AU. A table that can include up to 20 VLAN IDs. To
add a VLAN ID, double-click on a VLAN ID cell with a zero (0) value,
and enter the required value (1-4094). To remove a VLAN ID from the
table, double click on the relevant cell and delete its contents (or enter
0). To replace a VLAN ID, double-click on the relevant cell and enter
the new value.
If the VLAN Relaying Table is empty and the VLAN Relaying Support
is set to Enable, then all data frames are discarded. If VLAN Relaying
Support and VLAN Forwarding Support are both enabled, then all
VLAN IDs in the Relaying Table must also be included in the
Forwarding Table.