User manual

Chapter 2 - Managing a Single Device/Cell Bridging Page
AlvariCRAFT Device Manager 112 User Manual
VLAN ID (Inside
Extended Access Table -
SU only)
Defines the VLAN ID tag that is going to be applied to untagged
frames in the Ethernet to WLAN traffic. Also, any incoming WLAN
traffic tagged with this ID will be routed to Ethernet untagged. This
parameter must be configured in order to save the rule.
Valid values range from 1 to 4094.
If no value is defined for this entry, 0 is returned.
Priority (Inside Extended
Access Table - SU only)
Defines the priority tag that is going to be applied to untagged frames
in the Ethernet to WLAN traffic. This parameter impacts the way other
VLAN aware devices handle the frame. This parameter must be
configured in order to save the rule.
Valid values range from 0 to 7.
If no value is defined for this entry, 255 is returned.
Multicast (Inside
Extended Access Table -
SU only)
Defines whether multicast frames are filtered when applying the rule.
The available options are:
 Not Allowed - Multicast frames not allowed
 Allowed - Multicast frames allowed
This setting applies only to Layer 2 multicast frames. It does not apply
to Layer 2 broadcast frames or to Layer 3 broadcast or multicast
frames. For more information on this topic, see
Table 2-2.
Op Type (Inside
Extended Access Table -
SU only)
Defines the type of data that is defined in the VLAN Rule Data field.
The available options are:
 Value - A single value is entered
 Range - A range of consecutive values is entered by typing the
first and the last value in the range separated by a space or by a
minus symbol (-).
 Mask - An address - mask pair of entries is typed separated by a
space or comma symbol (,). The subnet defined in this manner
will be the applicable domain for the rule.
 Enumeration - A set of values is typed separated by comma
symbols (,).
The default setting is Value.