User manual

Chapter 2 - Managing a Single Device/Cell Bridging Page
AlvariCRAFT Device Manager 109 User Manual
VLAN Link Type This parameter enables defining the functionality of the VLAN aware
capability of the unit. The available options are:
 Hybrid Link
 Trunk Link
 Access Link (SU and RB Only)
 Service Provider Link (AU and SU Only)
 Extended Access Link (SU only)
 Extended Trunk Link (SU only)
Data VLAN ID Applicable only for SU and RB. The Data VLAN ID is applicable only
when the VLAN Link Type parameter is set to Access Link. It enables
defining the VLAN ID for data frames, which identifies the VLAN to
which the unit belongs.
Valid values range from 1 to 4094.
Management VLAN ID This parameter enables defining the VLAN ID for management
frames, which identifies remote stations for management purposes.
This applies to all management applications using protocols such as
SNMP, TFTP, ICMP (ping), DHCP and Telnet. All servers/stations
using these protocols must tag the management frames sent to the
unit with the value of the VLAN ID-Management parameter.
Valid values: 1 to 4094 or 65,535 (no VLAN).
Check the checkbox to enable configuring a value other than 65,535.
Uncheck it to force the value 65,535 (no VLAN).
Extended Trunk VLAN ID Applicable only for SU. This link type extends the Trunk mode’s
functionality by allowing it to also work with VLAN untagged frames
instead of dropping them. All untagged frames received via Ethernet
will be tagged with a predefined VLAN ID and routed to WLAN.
Consequently, tagged frames received over WLAN that match this
VLAN ID will be untagged before being routed to Ethernet. The exact
behavior is shown in
Table 2-1
Data VLAN Priority Applicable only for SU and RB. The Data VLAN Priority is applicable
for Access Links only. It enables configuring the value of the VLAN
Priority field for data frames transmitted to the wireless link. This
parameter only impacts the way other VLAN aware devices handle
the packet.
Valid values range from 0 to 7.