Specifications

Chapter 3 - Commissioning Configuring Basic Parameters
BreezeACCESS 4900 52 System Manual
3.1.2 Country Code Selection
3.1.3 Transmit Power Compliance With Regulations
NOTE (Japan 4.9 GHz, 10 MHz Bandwidth):
In BreezeACCESS units operating in the 4.9 GHz Japan band (not B&B
point-to-point) with a 10 MHz bandwidth, the following rules must be met for full
compliance with regulations:
1 When operating at 4945 MHz, the Transmit Power parameter in the AU should
not be set to a value above 11 dBm. The Maximum Transmit Power of the SU
should not be set to a value above 10 dBm.
Key 1 to Key 4 00……0 (32 zeros, meaning no key)
NOTE
Some parameters are changed to their new values only after reset (refer to Appendix E for more
details). After the basic parameters are configured, the unit should be reset in order to activate the
new configuration.
CAUTION
The selected Country Code must comply with applicable local radio regulations.
CAUTION
In regions where local radio regulations limit the maximum transmit power of the unit the installer is
responsible to properly set the Antenna Gain parameter (if configurable) according to the actual
antenna being used. This will limit the upper limits of the Tx Power parameter in the AU and the
Maximum Tx Power in the SU (where applicable) to the value of "Permitted EIRP-Antenna Gain".
The Tx Power parameter in the AU and the Maximum Tx Power in the SU (where applicable) should
not exceed the Permitted EIRP-Antenna Gain, according to the following table:
Table 3-2: Regulation Maximum EIRP
Country Code Maximum EIRP (dBm)
20 MHz Bandwidth 10 MHz Bandwidth
Japan 4.9 GHz 34 34 (NOTE 1)
Brazil 4.9 GHz 29 26
Table 3-1: Basic Parameters
Parameter Default Value Comment