Specifications

Chapter 2 - Installation Installing the Universal IDU Indoor Unit
BreezeACCESS 4900 40 System Manual
2.4 Installing the Universal IDU Indoor Unit
The unit can be placed on a desktop or a shelf. Alternatively, it may be
wall-mounted using the kit supplied with the unit.
The RADIO connector and RESET button are located on the front panel, the
ETHERNET connector is located on the side panel and LEDs are located on the
top panel.
1 Connect the Indoor-to-Outdoor cable to the RADIO connector, located on the
front panel of the indoor unit.
2 Connect the power cord to the unit's AC socket, located on the rear panel.
Connect the other end of the power cord to the AC mains. The unit can operate
with AC mains of 100-240 VAC, 50-60 Hz.
3 Verify that the POWER LED is lit, indicating that power is supplied to the unit.
Figure 2-6: IDU PS 1073 Front Panel
CAUTION
Do not connect the data equipment to the RADIO port. The RADIO port supplies DC power to the
ODU, and this may harm other equipment connected to it.
To install the IDU:
NOTE
The color codes of the power cable are as follows:
Brown
Blue
YellowGreen
Phase
Neutral
Ground
~
0