Specifications

Chapter 2 - Installation Installing the Outdoor Unit
BreezeACCESS 4900 37 System Manual
2 Connect the other end of the RF cable to the antenna.
3 The RF connectors should be properly sealed to protect against rain and
moisture.
2.3.4 Connecting the Indoor-to-Outdoor Cable
2.3.4.1 Units with an Installed Waterproof Seal
1 Remove the two screws holding the waterproof seal to the outdoor unit and
remove the waterproof seal.
Figure 2-4: Bottom Panel of the Outdoor Unit (without the seal assembly)
NOTE
The MAC Address of the unit is marked on both the ODU and the indoor unit (on the print side of the
BS-AU module or on the bottom side of the Universal IDU). If for any reason the ODU is not used
with the IDU with which it was shipped, the MAC Address of the system is in accordance with the
marking on the ODU.
To connect the indoor-to-outdoor cable: