Specifications

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS 4900 160 System Manual
The default selection is Disable.
4.2.6.4.3.2 Ethernet Broadcast/Multicast Limiter Threshold
The Ethernet Broadcast/Multicast Limiter Threshold defines the maximum
number of packets per second that will pass the limiter when it is enabled.
The range is from 0 to 204800 (packets/second).
The default is 50 packets.
4.2.6.4.3.3 Ethernet Broadcast/Multicast Limiter Send Trap Interval
The Ethernet Broadcast/Multicast Limiter Send Trap Interval defines the
minimum time in minutes between two consecutive transmissions of the trap
indicating the number of packets that were dropped by the limiter since the
previous trap (or since the time that the limit has been exceeded).
The range is from 1 to 60 minutes.
The default is 5 minutes.
4.2.6.4.4 Bridge Aging Time
The Bridge Aging Time parameter enables selecting the bridge aging time for
learned addresses of devices on both the wired and wireless sides, not including
BreezeACCESS 4900 units.
The available range is 20 to 2000 seconds.
The default value is 300 seconds.
4.2.6.4.5 Broadcast/Multicast Relaying (AU only)
The Broadcast/Multicast Relaying option enables selecting whether the unit
performs relaying of broadcasts and/or multicasts.
The available options are:
 Disable
 Broadcast/Multicast Enable
 Broadcast Enable
 Multicast Enable
If broadcast/multicast relaying if disabled, these packets are sent only to the local
wired LAN and are not sent back to the wireless link. When broadcast and or
multicast relaying is enabled, the relevant packets (broadcasts only, multicasts
only or both broadcasts and multicasts) originating from devices on the wireless