Specifications

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS 4900 151 System Manual
4.2.6.4.1.5 VLAN Relaying (AU only)
The VLAN Relaying feature is applicable only for Trunk Links and Service Provider
Links. It enables defining the VLAN ID values to be included in the VLAN Relaying
List.
If the Link Type is defined as either a Trunk Link or a Service Provider Link and
the VLAN Relaying Support option is enabled, a frame relayed from the wireless
link, which is a frame received from the wireless link that should be transmitted
back through the wireless link, with a VLAN ID (or a Service Provider VLAN ID)
that is not a member of the unit's VLAN Relaying List, is discarded. If VLAN
Forwarding Support is also enabled, it is necessary to configure all the VLAN IDs
in the Relaying List also in the Forwarding List to enable the relaying operation.
The VLAN Relaying menu provides the following options:
4.2.6.4.1.5.1 VLAN Relaying Support
The VLAN Relaying Support option enables or disables the VLAN Relaying feature.
Available selections are Disable and Enable.
The default selection is Disable.
4.2.6.4.1.5.2 Add Relaying VLAN ID
The Add Relaying VLAN ID option enables adding a VLAN ID to the VLAN Relaying
List. One VLAN ID can be entered at a time. The maximum number of VLAN IDs in
the VLAN Relaying List is 20.
Valid values are 1 to 4094.
4.2.6.4.1.5.3 Remove Relaying VLAN ID
The Remove Relaying VLAN ID option enables removing a VLAN ID from the VLAN
ID Relaying List. Valid values are VID values (from 1 to 4094)) that are included in
the VLAN Relaying List.
4.2.6.4.1.5.4 Show VLAN ID Relaying List
The Show VLAN Relaying option displays the values of the VLAN IDs included in
the VLAN Relaying List.
NOTE
If the VLAN ID Forwarding List is empty and the VLAN Forwarding Support is set to Enable, then all
data frames are discarded.
If VLAN Relaying Support and VLAN Forwarding Support are both enabled, then all VLAN IDs
configured in the Relaying List must also be configured in the Forwarding List.