Specifications

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS 4900 140 System Manual
4.2.6.3.6.1 Set/Change Network Management IP Address Ranges
The Set/Change Network Management IP Address Ranges option enables
defining/updating up to 10 IP address ranges from which the unit can be
managed if the Network Management Filtering option is enabled.
The default Network Management IP Address Range is 0.0.0.0 TO 0.0.0.0 (all 10
ranges).
A range can be defined using a string that includes either a start and end address,
in the format "<start address> to <end address>" (example: 192.168.1.1 to
192.168.1.255), or a base address and a mask, in the format "<base address>
mask <mask>" (example: 192.168.1.1 mask 255.255.255.0).
4.2.6.3.6.2 Delete Network Management IP Address Range
The Delete Network Management IP Address Range option enables deleting IP
address range entries from the Network Management IP Address Ranges list.
4.2.6.3.6.3 Delete All Network Management IP Address Ranges
The Delete All Network Management IP Address Ranges option enables deleting all
entries from the Network Management IP Address Ranges list.
4.2.6.3.7 SNMP Traps (AU Only)
The SNMP submenu enables or disables the transmission of SNMP Traps. If this
option is enabled, up to 10 IP addresses of stations to which SNMP traps are sent
can be defined.
Starting on SW Version 5.0, traps are generated and sent only by the AU: relevant
events in an SU are reported by the SU to the serving AU that generates the
applicable trap on behalf of the SU.
For more details on the system traps see the relevant Traps document.
4.2.6.3.7.1 Send SNMP Traps
The Send SNMP Traps option enables or disables the sending of SNMP traps.
The default selection is Disable.
4.2.6.3.7.2 SNMP Traps Destination IP Addresses
The SNMP Traps Destination IP Addresses submenu enables defining up to 10 IP
addresses of devices to which the SNMP Traps are to be sent.
The default of all 10 SNMP Traps IP destinations is 0.0.0.0.