Specifications

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS 4900 104 System Manual
» The aging time specified for entries in these table. There is no aging time
for Association Info entries.
» The maximum number of entries permitted for this table, which is specified
by the Maximum Number of Associations parameter. The default value of
the Maximum Number of Associations parameter is 512.
 Show MIR/CIR Database: Displays information on the MIR/CIR support for
associated Subscriber Units.
Each entry includes the following information:
» The MAC address of the associated Subscriber Unit
» The values of the MIR and CIR parameters configured in the applicable SU
for the downlink (AU to SU) and for the uplink (SU to AU)
» The value configured in the applicable SU for the Maximum Delay
parameter
» The Unit Name of the SU
» The SW version of the SU
» The Unit Type of the SU
» IP Address
 Display MAC Pinpoint Table: The MAC Pinpoint table provides for each of the
Ethernet stations (identified by the MAC Address) connected to either the AU
or to any of the SUs served by it, the identity (MAC Address) of the wireless
device to which they are connected.
NOTE
An SU is only removed from the list of associated SUs under the following conditions:
 The SU failed to respond to 100 consecutive data frames transmitted by the AU and is
considered to have "aged out".
 During the last 6 minutes (or more) the SU did not transmit any data frame, and failed to
respond to certain frames that typically are transmitted by the AU every 10 seconds. Since the
sampling interval for this state is about 10 minutes, it means that the decision to remove the SU
from the Associations Database will take place between 6 to 16 minutes from the time the SU
ceased sending data or responding to these "keep-alive" frames (for AUS the sampling interval
is 1 minute, meaning decision time of 6 to 7 minutes).