Specifications

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS 4900 89 System Manual
4.2.3.13.2.1.3Threshold Target
This option defines the threshold target value. Depending on the threshold type,
the following value ranges apply:
If all the thresholds that were set up are reached, the entire SNR bar will light up.
For instance, if LEDs 2, 5 and 6 have thresholds set for them (the rest of the SNR
LEDs are disabled) and all these thresholds are reached, instead of having only
LEDs 2, 5 and 6 light up, all the SNR LEDs will light up.
4.2.3.13.2.2 Show LED stats
This option displays all the threshold settings that were applied for each LED in
the SNR bar.
4.2.4 Basic Configuration Menu
The Basic Configuration menu includes all parameters required for the initial
installation and operation of the unit. After the unit is properly installed and
operational, additional parameters can be configured either locally or remotely
using Telnet or SNMP management.
The Basic Configuration menu enables to access the following parameter sets:
4.2.4.1 IP Parameters
 IP Address
 Subnet Mask
 Default Gateway Address
Table 4-5: Threshold Target Value Ranges
Threshold Type Value Range
RSSI -108...0
CRC % 0...100
SNR 0...80
Average Modulation 1...8
NOTE
All parameters in the Basic Configuration menu are also available in the relevant sub menus of the
Advanced Configuration menu.