Specifications

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS 4900 78 System Manual
4.2.3.2.1.3 Set Complete Operators Defaults
Select this option to reset the unit to the Operator Defaults configuration,
excluding several parameters that are listed in Table 4-3.
4.2.3.2.1.4 Set Partial Operator Defaults
Select this option to reset the unit to the Operator Defaults configuration,
excluding the parameters that are required to maintain connectivity and
management access. The parameters that do not change after Set Partial Operator
Defaults are listed in Table 4-4.
Network Management Parameters Wi2 IP Address (SU)
Performance Parameters Adaptive Modulation Decision Thresholds
Bridge Parameters VLAN ID - Management
Service Provider VLAN ID (SU)
VLAN QinQ Protocol Ethertype
MAC Address List (AU)
MAC Address List Action (AU)
Service Parameters DRAP Option (AU)
UDP Port (AU)
Max Number of Voice Calls (AU)
DRAP TTL (AU)
Wireless Link Prioritization Option (AU)
Low Priority AIFS (AU)
Number of HW Retries for High Priority Traffic (AU)
Number of HW Retries for Low Priority Traffic (AU)
AU Burst Duration for High Priority Traffic (AU)
AU Burst Duration for Low Priority Traffic (AU)
SU Burst Duration for High Priority Traffic (AU)
SU Burst Duration for Low Priority Traffic (AU)
Low Priority Minimum Traffic Percent
Country Code Parameters Selected Country Code
Table 4-4: Parameters that are not reset after Set Partial Factory/Operator Defaults
Parameters Group Parameter