Specifications

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS 4900 76 System Manual
4.2.3.2.1.2 Set Partial Factory Defaults
Select this option to reset the unit to the standard Factory Default configuration,
excluding the parameters that are required to maintain connectivity and
management access. The parameters that do not change after Set Partial Factory
Defaults are listed in Table 4-4.
Air Interface Parameters Selected Sub-Band (AU)
Frequency (AU)
DFS Required by Regulations
Frequency Subset (AU)
Antenna Gain (AU)
Country Code Parameters Selected Country Code
NOTE
The FTP parameters are not set to their default values after Set Complete Operator Defaults.
However, they are set to their default value after Set Complete Factory Defaults. Note that in this
case they are set to the default values immediately upon selecting the Set Complete Factory
Default option (even before the next reset).
Table 4-4: Parameters that are not reset after Set Partial Factory/Operator Defaults
Parameters Group Parameter
Unit Control parameters Passwords
Ethernet Port Negotiation Mode
FTP Server IP address
FTP Gateway IP Address
FTP User Name
FTP Password
IP Parameters IP Address
Subnet Mask
Default Gateway Address
DHCP Option
Access to DHCP
Table 4-3: Parameters not reset after Set Complete Factory/Operator Defaults
Parameters Group Parameter