Specifications

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS 4900 75 System Manual
4.2.3.2.1 Set Defaults
The Set Defaults submenu enables reverting the system parameters to a
predefined set of defaults. There are two sets of default configurations:
A Factory Defaults: This is the standard default configuration.
B Operator Defaults: Operator Defaults configuration can be defined by the
Administrator using the Save Current Configuration As Operator Defaults
option in this menu. It may also be defined at the factory according to specific
operator's definition. The default Operator Defaults configuration is the
Factory Defaults configuration.
The current configuration file and the Operator Defaults configuration file can be
uploaded/downloaded by the unit using FTP. For more information, see
“Configuration File Upload/Download” on page 85 option. These files can also be
uploaded/downloaded remotely using TFTP (see Appendix B).
The available options in the Set Defaults submenu are:
 Set Complete Factory Defaults
 Set Partial Factory Defaults
 Set Complete Operator Defaults
 Set Partial Operator Defaults
 Cancel Current Pending Request
4.2.3.2.1.1 Set Complete Factory Defaults
Select this option to reset the unit to the standard Factory Defaults configuration,
excluding several parameters that are listed in Table 4-3.
Table 4-3: Parameters not reset after Set Complete Factory/Operator Defaults
Parameters Group Parameter
Unit Control Parameters All Passwords
FTP Server IP address* (see note below)
FTP Gateway IP address* (see note below)
FTP User Name* (see note below)
FTP Password* (see note below)
Ethernet Port Negotiation Mode