User manual

Network Management Parameters
BreezeCONFIG for BreezeACCESS VL and BreezeACCES 4900 User Manual
61
 Delete Entries: From the dropdown list, select an entry to be deleted from the
Network Management IP Address table. The options in the dropdown list
relate to the row of the table in which the required IP address is listed.
 Delete All Entries: Mark the check box to delete all the entries from the
Network Management IP Address table.
2.6.1.2 AP Client IP (SU only)
The AP Client IP parameter enables configuring in the SU the IP address of a WiFi
AP connected to it, providing availability of the IP address information for remote
management of the AP. Applicable only for WI
2
installations.
2.6.1.3 Network Management IP Address Ranges Table
This table enables defining IP address ranges of stations that are allowed to
manage the unit (in addition to the discrete IP addresses that can be defined in
the Network Management IP Addresses table).
The table includes up to 10 entries. Each entry includes:
 Define Range By: Indicates whether the range is defined by Start and End
Address or Start and Subnet Mask.
 Start: The start IP address.
 End: The end IP address. Applicable only for Start and End Address definition
method.
 Subnet Mask: The subnet mask for the range. Applicable only for Start and
Subnet Mask definition method.
To define/modify a management IP range:
1 Click on the required Define Range By entry. A drop-down menu will appear,
enabling selection between the two definition methods.
2 Select the preferred definition method.
3 Enter the Start IP address and the End IP address or Subnet Mask according
to the selected definition method.