User manual

Air Interface Parameters
BreezeCONFIG for BreezeACCESS VL and BreezeACCES 4900 User Manual
51
country. In these cases the Country Code includes a 4 digits proprietary
group code and the Country Group name (for example FCC).
 A country dependent parameters table that display the following parameters
for each of the available Sub-Bands:
 No.: Sub-Band ID
 Sub-Band: The frequency range available when using the Sub-Band.
NOTE
In some cases, the width of the Sub-Band column is not sufficient to display all available
frequencies. Double-click the applicable Sub-Band entry to view the complete list of frequencies in
a special pop-up message box.
 Bandwidth: The bandwidth when using the Sub-Band. If more than one
bandwidth is allowed, than each bandwidth is associated with a different
Sub-Band, since the bandwidth may affect the available frequencies.
 Max Tx Power: The maximum transmit power allowed at the antenna port
of the unit.
 Max EIRP: The maximum allowed EIRP (Effective Isotropic Radiated
Power).
 Min Mod Level: The lowest allowed modulation level
 Max Mod Level: The highest allowed modulation level
 Burst Mode: Indicates whether Burst Mode operation is supported.
 Max Burst Duration: If Burst Mode is supported, this parameter displays
the upper limit for the Maximum Burst Duration parameters.
 DFS: Indicated whether the DFS (Dynamic Frequency Selection)
mechanism for identification and avoidance of channels with radar activity
is supported.
 Sub-Band Index: Available where more than one Sub-Band is available,
enabling to select the Sub-Band to be used. In AU, this is the sub-band to be
used for planned frequencies in the Frequency tab and for Spectrum Analysis.
In SU, this is the sub-band to be used during Spectrum Analysis.