User manual

Unit Configuration
BreezeCONFIG for BreezeACCESS VL and BreezeACCES 4900 User Manual
50
2.4.3.5 Tx Control (AU only)
The Tx Control parameters enables turning Off/On the AU’s transmitter, or
having the Tx status controlled by the status of the Ethernet port/link.
If the selected option is Ethernet Status Control, then:
 If the Ethernet link is down, the AU’s transmitter will be switched to Off.
 If the Ethernet link is up, the AU’s transmitter will be switched to On.
This feature can be used during maintenance or testing to avoid transmissions
using undesired parameters.
The Tx Control parameter is available only when managing the unit from its
Ethernet port.
2.4.4 Air Interface Country Parameters Tab
The Country Parameters tab displays the country dependent parameters of the
available Sub-Band(s). Where more than one Sub-Band is available, it enables
Sub-Band selection.
Figure 2-15: Country Parameters Tab
The Country Parameters tab is comprised of the following components:
 Country Code: The up to 3 digits country code according to ISO 3166 and
the country name. Some regulatory requirements apply to more than one