User manual
Unit Configuration
BreezeCONFIG for BreezeACCESS VL and BreezeACCES 4900 User Manual
48
2.4.3.1 Transmit Power Table
The Transmit Power Table includes the following read-only components for each
of the applicable modulation levels:
Max Tx Power Range: The range available for the applicable Tx Power
parameter.
In AU, the range is defined by the hardware of the unit. In some cases the
upper boundary may be limited by the Maximum Tx Power as defined in the
Sub-Band, and/or by the Max EIRP as defined in the Sub-Band together with
the Antenna Gain parameter.
In SU the maximum value is determined by the value of the applicable Max
Tx Power entry in the Maximum Transmit Power Table.
Tx Power: The functionality differs between AU and SU:
In AU: The transmit power in dBm defined for the applicable modulation level.
In SU: If ATPC is disabled, this is the transmit power in dBm defined for the
applicable modulation level. If ATPC is enabled, it serves as the initial
transmit power in dBm for the ATPC algorithm.
The value of Tx Power for Modulation Level 1 to 5 is set by the Transmit
Power parameter (below the table). For other modulation levels, the Tx Power
is set to the minimum between the value of the Transmit Power parameter
and the maximum Tx power allowed by the HW and the Country Code for the
specific modulation level.
Current Tx Power (Applicable in SU only, NA in AU): The actual transmit
power in dBm for the applicable modulation level.
2.4.3.2 Maximum Transmit Power Table (SU only)
The Maximum Transmit Power Table includes the following read-only
components for each of the applicable modulation levels:
Defined Max Tx Power Range: The range available for the applicable Max Tx
Power parameter. The range is defined by the hardware of the unit. In some
cases the upper limit may be limited by the Maximum Tx Power as defined in
the Sub-Band, and/or by the Max EIRP as defined in the Sub-Band together
with the Antenna Gain parameter.
Max Tx Power: The maximum level of the Tx Power. The value for Modulation
Level 1 to 5 is set by Maximum Tx Power parameter (below the table). For
other modulation levels, the Max Tx Power is set to the minimum between the