WBSAC-2450 QUICK INSTALLATION GUIDE
Package Content WBSac-2450 access point Wall Mount Base Pole Mount Bracket Pole mounting steel band Wall mounting bots X 4 Mounting screws X 8 5GHz Omni antennas X 2 (for –O products only) 2.
Mounting WBSac-2450 units support both pole and wall mounting, as shown in the following illustrations. As the first step of each installation, attach the wall mount base to the back of the unit using 4 of provided mounting screws Pole Installation 1. Attach the pole mount bracket to the wall mount base using additional 4 provided mounting screws.
2. Insert the provided steel band through the slots of the pole mount bracket, loop it around the pole and tighten the band screw with appropriate screw driver to ensure that the unit is firmly in place. Note: For best performance of WBSac-2450 unit with integrated sector antennas, the recommendation is to install using a horizontal pole mount, as it offers a wider range of directional adjustment. When installing such unit on a vertical pole - tilting kit may be required.
Grounding Use provided ground screw to attached grounding cable to the device. Warning: You must always install an external grounding wire, as shown below. Ensure that you have completed grounding before you connect power to the WBSac unit Connecting the antennas This section refers to Omni products (-O) only. Each provided antenna is labeled to show its operating band. 1. Assemble 2.4GHz antennas on the top of the device. 2.
Connecting Power and DATA to the WBSac base station Warning: Before applying power to the device, ensure that all the antennas are connected 1. Connect one end of the Ethernet cable into the LAN port (PoE) of the Access Point (see sealing gland installation chapter bellow) and the other end to the "PoE" port on the PoE injector. 2. Connect the PoE injector in to an electrical outlet using the supplied cable. 3.
Safety instructions and information Please ensure that you read and understand the following safety information. Ensure that you carefully read and follow all instructions in this manual, and heed all warnings. Warnings It is illegal to modify the construction of this product. Modifying the operating frequency or enhancing the transmit output power through the use of external amplifiers or other equipment is specifically disallowed by the "Telecommunications Act”.
Lightning Protection The following procedure describes how to correctly ensure that your device is protected against lightning. For the best protection, two instances of the lightning protection device should be used. Use lightning protectors that are recommended by Alvarion. 1. Position one of the lightning protection devices as close to the building entrance as possible and connect it to the grounding bar of the building. 2.
Configuring WBSac Using a Browser 1. In an internet browser, enter the Management IP address of the WBSac unit in the URL navigation field. (Default: http://192.168.1.1, currently supported browsers: Microsoft Internet Explorer, Chrome and Mozilla Firefox.) 2. A log-in screen is displayed. Enter admin in the User Name field, and also enter admin in the password field. 3. Set DHCP server IP address 4. Set Arena controller IP address ( in case using Arena controller) 5.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC- Professional installation instruction 1. Installation personal This product is designed for specific application and needs to be installed by a qualified personal who has RF and related rule knowledge. The general user shall not attempt to install or change the setting. 2. Installation location The product shall be installed at a location where the radiating antenna can be kept 27cm from nearby person in normal operation condition to meet regulatory RF exposure requirement. 3.
