User's Manual

Chapter 4 - Operation and Administration
BreezeNET B System Manual
4-34
 Select DHCP Only to cause the unit to search for and acquire its IP
parameters, including the IP address, subnet mask and default
gateway, from a DHCP (Dynamic Host Configuration Protocol) server
only. If this option is selected, you must select the port(s) through
which the unit searches for and communicates with the DHCP
server, as described in the following parameter,
Access to DHCP.
You do not have to configure static IP parameters for the unit. The
units as management frames handle DHCP messages.
 Select Automatic to cause the unit to search for a DHCP server and
acquire its IP parameters from the server. If a DCHP server is not
located within approximately 40 seconds, the currently configured
parameters are used. If this option is selected, you must configure
the static IP parameters as described above. In addition, you must
select the port(s) through which the unit searches for and
communicates with the DHCP server, as described in the following
parameter,
Access to DHCP.
The default is Disable.
Access to DHCP
The Access to DHCP option enables defining the port through which the
unit searched for and communicate with a DHCP server. Select from the
following options:
 From Wireless Link Only
 From Ethernet Only
 From Both Ethernet and Wireless Link
The default for BU is From Ethernet Only. The default for RB is From
Wireless Link Only.
Show IP Parameters
The Show IP Parameters option displays the current values of the IP
parameters, including the Run Time IP Address, Run Time Subnet
Mask and Run Time Default Gateway Address.