User's Manual

Chapter 4 - Operation and Administration
BreezeNET B System Manual
4-12
Table 4-3: Parameters that are not reset after Set Partial Factory/Operator Defaults
(Using Administrator Access Rights)
Parameters Group Parameter
Authentication Algorithm
Default Key (RB)
Data Encryption Mode
Security Mode
Security Parameters
Key # 1 to Key # 4
VLAN ID - Data (RB)
VLAN ID - Management
VLAN Link Type
VLAN Forwarding Support
VLAN Forwarding ID (1 - 20)
VLAN Priority - Data (RB)
VLAN Priority - Management
Bridge Parameters
VLAN Priority Threshold
NOTE
This table details all the parameters that do not change after Set Partial
Factory/Operator Defaults using Administrator access rights. When performing Set
Partial Factory/Operator Defaults using Installer access rights, only parameters
accessible to Installers are reset to their default values (provided they are not included
in the list of parameters necessary to ensure connectivity and management access).
The parameters that are reset to their default values in this case are Unit Name, SW
Version File Name, Configuration File Name, Operator Defaults File Name, FTP
Source Dir, Ethernet Port Negotiation Mode and Log Out Timer. All other parameters
are not changed after Set Partial Factory/Operator Defaults using Installer access
rights.
 Set Complete Operators Defaults: Available only with
Administrator access rights. Resets the unit to the Operator
Defaults configuration, excluding several parameters that are listed
in Table 4-2.