User's Manual

Menus and Parameters
Manual Revision 1.0
4-9
Unit Control Menu
The Unit Control menu enables configuring control parameters for the
unit. The Unit Control menu includes the following options:
Reset Unit
The Reset Unit option enables resetting the unit. After reset, any
modifications made to the system parameters are applied.
Default Settings
The Set defaults submenu enables resetting the system parameters to a
predefined set of default or saving the current configuration as the set
of Operator Defaults. The available options are:
Set Defaults:
The Set Defaults submenu enables reverting the system parameters to a
predefined set of defaults. There are two sets of default configurations:
A. Factory Defaults: This is the standard default configuration.
B. Operator Defaults: Operator Defaults configuration can be defined
by the Administrator using the Save Current Configuration As
Operator Defaults option in this menu. It may also be defined at the
factory according to specific operator's definition. The default
Operator Defaults configuration is the Factory Defaults
configuration.
The current configuration file and the Operator Defaults configuration
file can be uploaded/downloaded by the unit using FTP. For more
information, see
Configuration File Upload/Download
option on
page 4-16. These files can also be uploaded/downloaded remotely using
TFTP (see
Appendix B - Configuration Download and Upload Using
TFTP).
The available options in the Set Defaults submenu are:
 Set Complete Factory Defaults: Available only with Administrator
access rights. Resets the unit to the standard Factory Defaults
configuration, excluding several parameters that are listed in Table
4-2.