User's Manual

Installing the Universal IDU Indoor Unit
Manual Revision 1.0
2-9
Installing the Universal IDU Indoor
Unit
The unit can be placed on a desktop or a shelf. Alternatively, it may be
wall-mounted. The drilling template included with the unit can be used
to simplify the wall installation process1
Figure 2-5: IDU Front Panel
1. Connect the Indoor-to-Outdoor cable to the RADIO connector,
located on the front panel of the indoor unit shown in Figure 2-5.
2. Connect the power cord to the unit's AC socket, located on the rear
panel. Connect the other end of the power cord to the AC mains
after verifying that the unit is rated for the voltage in the country of
use; the AC raing is indicated on the rear panel of the Indoor unit.
NOTE
The color codes of the power cable are as follows:
Brown Phase ~
Blue Neutral 0
Yellow/Green Ground
3. Verify that the yellow POWER LED located on the front panel is lit,
indicating that the unit is supplying power to the radio port.
4. Configure the basic parameters as described in Configuring Basic
Parameters on page 3-2.
To install the IDU: