User's Manual

Chapter 2 - Installation
BreezeNET B System Manual
2-8
6. Replace the waterproof seal and then the top nut. Make sure that
the external jack of the cable is well inside the waterproof seal to
guarantee a good seal.
7. Route the cable to the location selected for the indoor equipment.
8. Assemble an RJ-45 connector with a protective cover on the indoor
end of the indoor-to-outdoor cable.
Units with a waterproof seal supplied
with the Ethernet cable
1. Verify that the o-ring supplied with the cable kit is in place.
2. Connect the RJ-45 connector of the Ethernet cable to the outdoor
unit.
3. Attach the waterproof seal to the unit. Tighten the top nut.
4. Route the cable to the location selected for the indoor equipment.
5. Assemble an RJ-45 connector with a protective cover on the indoor
end of the indoor-to-outdoor cable.
See Appendix C - Preparing the Indoor to Outdoor Cable for
instructions on preparing the cable.
To connect the indoor-to-outdoor cable: