User's Manual

Connecting the Indoor-to-Outdoor Cable
Manual Revision 1.0
2-7
Connecting the Indoor-to-Outdoor
Cable
Units with an installed waterproof seal
1. Remove the two screws holding the waterproof seal to the outdoor
unit and remove the waterproof seal.
2. Unscrew the top nut from the waterproof seal.
Figure 2-4: The Waterproof Seal
3. Route a straight, uncrimped Cat. 5 Ethernet cable (8-wire, 24 AWG)
through both the top nut and the waterproof seal.
NOTE
The 8-wire cable should be shielded.
4. Insert and crimp the RJ-45 connector. Refer to
Appendix C for
instructions on preparing the cable.
5. Connect the Ethernet cable to the outdoor unit RJ-45 connector.
To connect the indoor-to-outdoor cable: