User's Manual

Chapter 2 - Installation
BreezeNET B System Manual
2-6
Connecting the Ground and Antenna
Cables
The Ground terminal (marked ╤) is located on the bottom panel of the
outdoor unit. The Antenna RF connector (marked
) is located on the
top panel of the D-model ODU.
1. Connect one end of a grounding cable to the ground terminal and
tighten the ground screw firmly.
2. Connect the other end of the ground cable to a ground connection.
1. Connect one end of the coaxial RF cable to the RF connector on the
top panel of the unit
2. Connect the other end of the RF cable to the antenna.
3. The RF connectors should be sealed properly to protect against rain
and moisture
Figure 2-3: Bottom Panel of the Outdoor Unit (without the seal assembly)
NOTE
The MAC Address of the unit is marked on both the ODU and the IDU (on the bottom
side of the unit). If due to any reason the ODU is not used with the IDU with whom it was
shipped, the MAC Address of the system is in accordance with the marking on the ODU.
To prepare the ground cable:
To connect the RF cable (D model):