User Manual

Appendix E - Parameters Summary
BreezeACCESS VL System Manual
222
Parameter Unit Range Default Run-Time
DFS Required by
Regulations **
AU  No
 Yes
Dependent on Country
DFS Support: If DFS is
supported by the country
code then the default will
be Yes, else it will be
No.
Yes
Frequency Subset
Definition (in AU)**
AU According to the Sub-Band. A
list of frequency indexes or A
for all frequencies supported
by the Sub-Band
A Yes
Channel Check Time** AU 1 – 3600 (seconds) 60 (seconds) Yes
Channel Avoidance
Period**
AU 1 – 60 (minutes) 30 (minutes) Yes
SU Waiting Option** AU  Disable
 Enable
Enable Yes
Minimum Pulses to
Detect**
AU 1-100 4 for FCC
8 for other (ETSI)
Yes
Clear radar Detected
Channels After Reset**
AU  Disable
 Enable
Disable Yes
Channel Reuse Option** AU  Disable
 Enable
Disable Yes
Radar Activity
Assessment Period**
AU 1 – 12 hours 5 hours Yes
Maximum Number of
Detections in
Assessment Period**
AU 1 – 10 detections 5 detections Yes
Country Code Learning
by SU
AU  Disable
 Enable
Disable Yes
Transmit Power AU, SU -10 dBm to a value that
depends on HW revision ,
Country Code / Antenna Gain
and (in SU) the Max Tx Power
parameter
The highest allowed
value
Yes
Maximum Tx Power SU -10 dBm to a value that
depends on HW revision and
Country Code / Antenna Gain
The highest allowed
value
Yes
ATPC Option AU, SU  Disable
 Enable
Enable Yes
Delta from Minimum SNR
Level
AU 4-20 (dB)  Units in 0.9, 5.4, 5.8
GHz bands: 5 (dB)
 Units in the 4.9, 5.2
and 5.3 GHz bands:
8 (dB)
Yes
Minimum SNR Level AU 4-60 (dB) 28 (dB) Yes
Minimum Interval
Between ATPC
Messages
AU 1-3600 (seconds) 30 (seconds) Yes
ATPC Power Level Steps AU 1-20 (dB) 4 Yes
Tx Control AU  Off
 On
 Ethernet Status Control
On Yes