User's Manual

Parameters Summary
BreezeACCESS VL System Manual
265
F.1.2 IP Parameters
Parameter Unit Range Default Run-Time
IP Address AU, SU IP address 10.0.0.1 No
Subnet Mask AU, SU IP address 255.0.0.0 No
Default Gateway Address AU, SU IP address 0.0.0.0 No
DHCP Option AU, SU
 Disable
 DHCP Only
 Automatic
Disable No
Access to DHCP AU, SU
 From Wireless Only
 From Ethernet Only
 From Both Wireless and
Ethernet
AU: From Ethernet Only
SU: From Wireless Only
No
F.1.3 Air Interface Parameters
Parameter Unit Range Default Run-Time
ESSID AU, SU Up to 31 printable ASCII
characters
ESSID1 No
Operator ESSID Option AU
 Disable
 Enable
Enable No
Operator ESSID AU Up to 31 printable ASCII
characters
ESSID1 No
Best AU Support SU
 Disable
 Enable
Disable No
Number of Scanning
Attempts
SU 1 – 255 4 No
Preferred AU MAC
Address
SU MAC Address 00-00-00-00-00-00
(no preferred AU)
Yes
Scanning Mode SU Passive, Active Passive No
Cell Distance Mode AU Automatic, Manual Automatic No
Maximum Cell Distance AU 0-54 (Km)
0 means no compensation
0 (no compensation) Yes
Fairness Factor AU 0 – 100 (%) 100 (%) No
Arbitration Inter-Frame
Spacing
AU, SU
 1 time slot
 2 time slots
2 time slots Yes
Per SU Distance
Learning
AU
 Disable
 Enable
Disable Yes
Wireless Trap Threshold AU 1-100 (%) 30 (%) Yes
Maximum Number of
Associations
AU AU-BS, AU-SA: 1-512 (1-124 if
Data Encryption Option is
enabled).
AUS-BS, AUS-SA: 1-8
AU-BS, AU-SA: 512
AUS-BS, AUS-SA: 8
Yes
Sub-Band Select* AU According to the Country Code 1 No
Frequency AU According to the Sub-Band The lowest frequency in
the Sub-Band
No
User Defined Frequency
Subsets
SU All frequencies in the available
Sub Bands
All available frequencies
in all available Sub
Bands
Yes