User's Manual

Appendix E - BreezeACCES VL MIB
BreezeACCESS VL System Manual
260
Trap (Number) Description Variables
below (Off) or increased above
(On) a threshold defined by
the *WirelessTrapThreshold.
*PowerUpFromReset (101) An AU/BU trap indicating
power up after reset.
*UnitMacAddress
*MonitorStatusTRAP (102) Applicable to all units. A trap
indicating that a log-in or
log-out has been performed
via Telnet. Includes the login
access right and the IP
address of the PC performing
Telnet.
*TrapLog
*TrapAccessRights
*TrapTelnetUserIpAddress
*ParameterChangedTRAP(103) Applicable to all units. A trap
indicating a change in
CIR/MIR, IP Filter or VLAN
parameter.
*TrapParameterChanged
*LoadingStatusTRAP(104) Applicable to all units. A trap
indicating the results
(successful or failed) of the
last FTP/TFTP loading
process.
*TrapFtpOrTftpStatus
*UnitMacAddress
*PromiscuousModeTRAP (105) An AU/BU trap indicating that
promiscuous mode was
enabled (on) or disabled (off)
*TrapToggle
*UnitMacAddress
*DFSRadarDetectedTRAP (106) An AU/BU trap indicating that
radar was detected
*UnitMacAddress
*DFSFrequencyTRAP (107) An AU/BU trap indicating the
new frequency after radar was
detected.
*TrapDFSMoveFreq (HW
Revision B and lower).
*TrapDFSMoveFreqNew (HW
Revision C and higher).
*DFSNoFreeChannelsExistTRAP (108) An AU/BU trap indicating that
radar was detected and there
is no free channel.
*UnitMacAddress
*EthBroadcastMulticatLimiterTRAP
(109)
Applicable for all units. The
trap is send if the Ethernet
broadcast filter threshold is
exceeded and it contains the
number of packets that were
dropped since the last trap.
*UnitMacAddress
*EthBroadcastThresholdExceeded
*UnsupportedSubscriberTypeTRAP (110) Applicable to AUS only. This
trap is generated when a
subscriber unit that is not
supported tries to associate
with the AUS. The AUS
supports only up to 8 SU-3
and/or SU-6 and/or SU-I units.
*TrapSUMacAddr
*TrapSubscriberType
*UnitTypeChangedTRAP (111) Applicable to BU/RB only. This
trap is generated when the
user changes the type of the
unit. The RB can be converted
to BU or vice versa.
*TrapMACAddress
*NewUnitType
*PrioritizationNotSupportedBySUTRAP (112) Applicable to AU only. This
trap is generated when an SU
with a SW version below 4.0
that does not support Wireless
Link Prioritization is associated
with an AU with the Wireless
Link Prioritization Option
enabled.
*TrapSUMACAddress
*TrapSWVersion