User's Manual

Appendix E - BreezeACCES VL MIB
BreezeACCESS VL System Manual
248
MIB Parameter Description Value/Range
transmit an unacknowledged frame
in each Hardware Retrials phase.
version below 4.0.
*AdaptiveModulationParams
(*PerformanceParams 9)
Adaptive Modulation Parameters
*AdaptiveModulationAlgorithmOption
(*AdaptiveModulationParams 1)
Applicable to all units.
Enabling/disabling the Adaptive
Modulation algorithm.
Integer
disable (1)
enable (2)
*SoftwareRetrySupport
(*AdaptiveModulationParams 2)
Applicable to all units. Read-
only for units with version 2.0. Not
applicable for units with SW version
3.0 and higher. The status of the
Software Retry mechanism.
Enabled when the Adaptive
Modulation algorithm is enabled
and the Burst Mode Option is
disabled. Otherwise it is disabled.
Integer
disable (1)
enable (2)
na (255)
*NumberOfSoftwareRetries
(*AdaptiveModulationParams 3)
Applicable to all units.
Read-only for units with version
2.0. Not applicable for units with
SW version 3.0 and higher. The
maximum number of times to use
the Software Retry mechanism
when it is enabled.
Integer
0-14
*MinimumIntervalBetweenAdaptiveModulation
AlgorithmMessages
(*AdaptiveModulationParams 4)
Applicable to all units. The
minimum interval between two
consecutive adaptive modulation
algorithm messages carrying
information on the SNR of received
signals.
Integer
1-3600 (seconds)
*AdaptiveModulationDecisionThresholds
(*AdaptiveModulationParams 5)
Applicable to all units. Defines the
setting of thresholds for the rate
decision algorithm. high (2) should
typically be used when the SNR is
lower than 13 dB.
Integer
normal (1)
high (2)
na (255)
*BurstMode
(*PerformanceParams 10)
Burst Mode Parameters. Applicable
to all units. Not applicable if
Wireless Link Prioritization is
enabled.
*BurstModeOption
(*BurstMode 1)
Applicable to all units. Applicable
only if Burst Mode Option is
supported by the Sub-Band. Not
applicable if Wireless Link
Prioritization is enabled.
Enabling/disabling burst mode
operation.
In SU/RB with HW Revision B or
lower blocked (3) value is returned
when Security Mode is Wep, Data
Encryption Option is Enabled and
Burst option is Enabled.
In AU/BU with HW Revision B or
lower blocked (3) value is returned
when Dfs Option is Enabled and
Burst mode is enabled.
Integer
disable (1)
enable (2)
blocked (3)
na (255)
*BurstInterval
(*BurstMode 2)
Applicable to all units. Not
applicable if Wireless Link
Prioritization is enabled. The burst
interval in milliseconds.
Integer
1-the maximum value as
defined in the Sub-Band.
(milliseconds)
na (255)
*ConcatenationParameters Concatenation Parameters.