User's Manual

Appendix E - BreezeACCES VL MIB
BreezeACCESS VL System Manual
244
MIB Parameter Description Value/Range
The time is given in 250
microseconds units.
*Drap
(*ServiceParameters 11)
DRAP Parameters.
Applicable only to AU with
SW version 4.0 and higher.
Not applicable to
BreezeNET Bproducts.
*DrapSupport
(*Drap 1)
Disable/Enable the DRAP
feature.
Integer
disable (1)
enable (2)
na (255)
*DrapUdpPort
(*Drap 2)
The UDP port used for the
DRAP server.
Integer
8000-8200
*DrapMaxNumberOfVoiceCalls
(*Drap 3)
The maximum number of
voice calls that can be
supported by the AU when
DRAP is enabled.
Integer
0-255
*DrapTTL
(*Drap 4)
The maximum time in
seconds between two
allocation requests.
Integer
1-255
*DrapNoOfActiveVoiceCalls
(*Drap 5)
Read-only. The current total
number of active voice calls.
Integer
*LowPriorityTrafficMinimumPercent
(*ServiceParameters 12)
The minimum percent of the
traffic rate that is allocated
to the low priority traffic.
Integer
0-100
E.2.8 User Filtering Parameters
MIB Parameter Description Value/Range
*UserFilterParams
(breezeAccessVLMib 8)
Applicable to SU/RB. User
filtering parameters.
*UserFilterOption
(*UserFilterParams 1)
Applicable to SU/RB.
Defines user-filtering
options.
disable: No filtering.
iPOnly: Only IP protocol
packets pass.
userDefinedAddrOnly: Only
IP frames from/to user
defined IP addresses pass.
pPPoE Only: Only PPPoE
frames pass.
Integer
disable (1)
ipOnly (2)
userDefinedAddrOnly (3)
pPPoEOnly (4)
na (255)
*IpFilterTable
(*UserFilterParams 2)
Applicable to SU/RB. A
table of up to 8 user defined
addresses, or address
groups, to be used if the
User Filtering Option
(*UserFilterOption) is
userDefinedAddrOnly. Not
accessible.
*IpFilterEntry
(*IpFilterTable 1)
Applicable to SU/RB. An IP
Filter table entry. Not
accessible.
*IpID
(*IpFilterEntry 1)
Applicable to SU/RB. An IP
address in the IP Filter
table.
IP Address