User's Manual

Appendix E - BreezeACCES VL MIB
BreezeACCESS VL System Manual
236
MIB Parameter Description Value/Range
ethernetStatusControl, the unit will
not transmit if the Ethernet link is
down. This parameter can be
configured only via the ethernet port.
In units with SW version below 4.0,
the unit is reset automatically upon
configuration. For unit with SW
version 4.0 and higher this
parameter is applied in run-time.
off (2)
ethernetStatusControl 3)
*LostBeaconsWatchdogThreshold
(*AirInterface 22)
Applicable to AU/BU only. The
number of unsuccessful consecutive
transmissions of beacons before
Internal refresh is performed. 0
means that the lost beacons
watchdog is not used and internal
refresh is not performed.
Integer
0, 100-1000
*TransmitPower
(*AirInterface 23)
Applicable to all units with SW
version 4.0 and higher. The
uniform transmit power for all
modulation levels. For a specific
modulation level the effective
transmit power (brzaccVLTxPower)
is the minimum between the uniform
transmit power and the maximum
transmit power for that modulation
level.
Integer
*MaximumTxPower
(*AirInterface 24)
Applicable to only SU/RB with SW
version 4.0 and higher. The
Maximum Transmit Power for all
modulation levels. The Maximum
Transmit Power for a specific
modulation level is the minimum
between this parameter and the
hardware limitation for that
modulation level.
Integer
E.2.7 Service Parameters
MIB Parameter Description Value/Range