User's Manual

Appendix E - BreezeACCES VL MIB
BreezeACCESS VL System Manual
230
MIB Parameter Description Value/Range
*CurrentFrequencySubsetTableIdx
(*CurrentFrequencySubsetEntry 1)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Read-only. The index of an
entry in the Current Frequency
Subset table.
Integer
*CurrentFrequencySubset
Frequency
(*FrequencySubsetEntry 2)
Applicable to all units with HW
revision B and lower (for units with
HW revision C and higher replaced
by
*CurrentFrequencySubsetFrequency
New to support a resolution of 0.5
MHz). Not applicable to SU/RB with
SW version 4.0 and higher. Read-
only. The frequency in MHz of an
entry in the Current Frequency
Subset table.
Integer
*CurrentFrequencySubset
FrequencyNew
(*FrequencySubsetEntry 3)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Read-only. The frequency in
MHz of an entry in the Current
Frequency Subset table. (Replaces
*CurrentFrequencySubsetFrequency
to support a resolution of 0.5 MHz
for units with HW revision C and
higher).
DisplayString
*CurrentAUOperatingFrequency
(*FrequencyDefinition 7)
Applicable to AU/BU with HW
revision B and lower (for units with
HW revision C and higher replaced
by
*CurrentUOperatingFrequencyNew
to support a resolution of 0.5 MHz).
Read-only. The operating frequency
in MHz.
Integer
For 5.8 GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using a 10 MHz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub-
Band.
*AUDefinedFrequency
(*FrequencyDefinition 8)
Applicable to AU/BU with HW
revision B and lower (for units with
HW revision C and higher replaced
by
*DefinedAUOperatingFrequencyNew
to support a resolution of 0.5 MHz).
Read-only. For 5.8 GHz products
with SW version below 2.0 this is the
frequency in MHz of the AU/BU after
the next reset.
For units with SW version 2.0 and up
this is the frequency in MHz to use
when the DFS Option is disabled.
Integer
For 5.8 GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using a 10M Hz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub-
Band.
*CurrentSUOperatingFrequency
(*FrequencyDefinition 9)
Applicable to SU/RB. Read only.
The current operating frequency in
MHz.
DisplayString
For 5.8 GHz products with
SW version below 2.0 the
range is 5740 to 5830 MHz
using a 10 MHz resolution.
For units with SW version
2.0 and up the range is as
defined in the selected Sub-
Band.
*SubBandSelect
(*FrequencyDefinition 10)
Sub-Band Selection parameters
*SelectSubBandIndex
(*SubBandSelect 1)
Applicable to all units. Read only for
SU/RB with SW version 4.0 and
Integer