User's Manual

breezeAccessVLMib
BreezeACCESS VL System Manual
225
MIB Parameter Description Value/Range
The highest distance from the
AU/BU of
any SU/RB served by it. Affects the
maximum time the units wait for a
response message and the slot size
by taking into account the round trip
propagation delay.
2.0 and up the range is 0 to
54 Kilometers.
0 means no compensation
(minimum slot size, maximal
delay timeout).
*AIFS
(*AirInterface 3)
Applicable to AU and SU. Not
applicable to BreezeNET B
products. Arbitration Inter-Frame
Spacing (AIFS). This is the number
of time slots that define the DIFS.
(DIFS=SIFS+AIFS). A value of 1
should be used only in point-to-point
applications to allow one unit to have
advantage over the other unit.
Integer
oneSlot (1)
twoSlots (2)
na (255)
*WirelessTrapThreshold
(*AirInterface 4)
Applicable to AU/BU only. A wireless
link quality threshold, expressed in
% of retransmissions, for sending
the
brzaccVLAUWirelessQualityTRAP.
This trap indicate whether the quality
has gone below or above the
specified threshold
Integer
1-100 (%)
*TransmitPowerTable
(*AirInterface 5)
Applicable to all units. Not
accessible. Transmit Power
parameters table.
*TransmitPowerEntry
(*TransmitPowerTable 1)
Applicable to all units. Not
accessible. An entry in the Transmit
Power parameters table.
*TransmitPowerIdx
(*TransmitPowerEntry 1)
Applicable to all units. Read-only. An
index of an entry in the Transmit
Power parameters table.
Integer
1-4
*ApplicableModulationLevel
(*TransmitPowerEntry 2)
Applicable to all units. Read-only.
The applicable modulation level for
an entry in the Transmit Power
parameters table. Level 8 is not
applicable to units with HW revision
A.
Level1to5 (1)
Level6 (2)
Level7 (3)
Level8 (4)
*MaximumTxPowerRange
(*TransmitPowerEntry 3)
Applicable to all units. Read-only.
The allowed range for the *TxPower
parameter at the applicable
modulation level.
DisplayString
Range: -10 to the maximum
allowed for the applicable
modulation level.
*TxPower
(*TransmitPowerEntry 4)
Applicable to all units. Read-only for
units with SW version 4.0 and
higher.
AU/BU: The transmit power defined
for the applicable modulation level.
SU/RB: If ATPC is disabled, this is
The transmit power defined for the
applicable modulation level. If ATPC
is enabled, it serves as the initial
transmit power for the ATPC
algorithm.
DisplayString
Range:
In SU/RB: The range is -10
dBm to the power value
defined by
*MaximumTxPower for the
applicable modulation level.
In AU/BU: The range is -10
dBm to the power value
defined by
*MaximumTxPowerRange
for the applicable modulation
level
*CurrentTxPower
(*TransmitPowerEntry 5)
Applicable to SU/RB. Read-only.
The actual transmit power in dBm at
the applicable modulation level.
DisplayString
Range: -17 to the maximum
value defined by