User's Manual

breezeAccessVLMib
BreezeACCESS VL System Manual
223
MIB Parameter Description Value/Range
packets. limitOnlyBroadcasts(2)
limitMulticastsExceptBro
adcasts(3)
limitAllMulticasts(4)
*EthBroadcastMulticastLimiterThreshold
(*EthBroadcastingParameters 5)
Applicable to all units. The limit for the
allowed number of multicast and
broadcast packets when the
Ethernet Broadcast/Multicast Limiter
Option is enabled
Integer
0 - 204800
*EthBroadcastMulticastLimiterSendTrapI
nterval
(*EthBroadcastingParameters 5)
Applicable to all units. The minimum time
in minutes between two successive traps
that are sent, indicating the number of
packets that were dropped by the
Ethernet Broadcast/Multicast Limiter since
the last trap was sent.
Integer
1-60
*ToSPriorityParameters
(*BridgeParameters 8)
*ToSPrecedenceThreshold
(*ToSPriorityParameters 1)
Applicable to all units. Not applicable to
units with SW version 3.1 and higher.
Priority threshold (based on the ToS) for
frames received from Ethernet port.
Integer
0-7
*RoamingOption
(*BridgeParameters 9)
Applicable to SU/RB only.Disable/enable
the roaming feature. When enabled, the
SU will start scanning for an AU/RB after
one second of not receiving beacons from
current AU/BU. Once it found a new
AU/BU, it will also send through the
wireless network a roaming SNAP on
behalf of its clients informing other
devices in the network of their new
location. When disabled, it will wait for
seven seconds before starting scanning,
and it will not send roaming SNAPs.
Integer
disable (1)
enable (2)
na (255)
*MacAddressDenyList
(*BridgeParameters 10)
MAC Address Deny List parameters
*MacAddressDenyListTable
(*MacAddressDenyList 1)
Applicable to AU only. Not applicable to
BreezeNET B units. A list of up to 100
MAC Addresses. If
brzaccVLMacAddressDenyListAction is
set to denyList, these are SUs that are not
allowed to transfer data to the AU.
If brzaccVLMacAddressDenyListAction is
set to allowList, only these SUs are
allowed to transfer data to the AU. Not
accessible.
*MacAddressDenyListEntry
(*MacAddressDenyListTable 1)
Applicable to AU only. Not applicable to
BreezeNET B units. An entry in the Mac
Address Deny List Table. Not accessible.
*MacAddressDenyListTableIdx
(*MacAddressDenyListEntry 1)
Applicable to AU only. Not applicable to
BreezeNET B units. A read only table
index for a MAC Address entry in the Mac
Address Deny List Table.
Integer
Range: 1 to 100
*MacAddressDenyListId
(*MacAddressDenyListEntry 2)
Applicable to AU only. Not applicable to
BreezeNET B units. The list of MAC
Addresses in the MAC Address Deny List
Table. To Remove a MAC Address - SET
the corresponding entry to 0. To Add a
new MAC Address - SET an entry which
is currently 0.
MAC Address
*MacAddressDenyListAdd Applicable to AU only. Not applicable to MAC Address