User's Manual

Configuring Basic Parameters
Commissioning
67
Table 3-1: Basic Parameters
Parameter Default Value Comment
Sub-Band Maximum Tx Power
parameter.
Maximum Tx Power (SU)
Dependent on HW
revision and Sub-Band
Maximum Tx Power
cannot be higher than the
upper limit according to
the Sub-Band in use.
Tx Power (AU) On
Antenna Gain (units with external
antenna)
According to the antenna
supplied with the unit and
the Sub-Band.
If set to “Not Set Yet”,
must be configured
according to actual value,
taking into account
cable’s attenuation.
ATPC Option Enable
Best AU Support (SU) Disable
Preferred AU MAC Address (SU) 00-00-00-00-00-00 (none)
Applicable only when
Best AU Support is
enabled.
Cell Distance Mode (AU) Automatic
Maximum Cell Distance (AU) 0 (No Compensation)
Fairness Factor (AU) 100 (%)
Per SU Distance Learning (AU) Disable
Maximum Modulation Level (SU)
8 (or the highest value
supported according to
the country code). No
higher than 7 for units
with HW revision A.
Refer to section 3.4.
VLAN ID-Management 65535