User's Manual

Installing the SU-I
Installation
53
 Simple window mounting accessories, enabling installation on a glass window
(without any capability for adjusting the direction). For installation
instructions see Section 2.5.5.3
.
 Window mounting kit with rotation capability, enabling installation on a glass
window (with rotation capability for adjusting the direction). For installation
instructions see Section 2.5.5.4
.
NOTE
Ensure that the antenna is mounted vertical to the floor, with the connector facing downward, and
the front of the antenna facing to the exterior of the building, preferably directed towards the Base
Station.
2.5.5.1 Wall Mount
The installation kit includes 2 plastic anchors and 2 #8 screws.
7 If anchors are needed (wall-board, plaster board, etc.), drill two holes for the
anchors using a 5 mm drill bit and insert anchors. Use a 9/64" drill bit for
screwing directly into a solid surface (stud).
8 Fasten the antenna to the wall. Refer to Figure 2-15 for directions. Use the
two #8 screws provided with the kit. Do not over tighten.
9 Connect the antenna cable to the connector located on the bottom side of the
antenna. Hand tighten, do not use a wrench or a similar tightening tool. Do
not over tighten.