User's Manual

Appendix F - Parameters Summary
BreezeACCESS VL System Manual
270
* Applicable only if Burst Mode is supported by the Sub-Band.
F.1.7 Service Parameters
Parameter Unit Range Default Run-Time
User Filtering Option SU
 Disable
 IP Protocol Only
 User Defined Addresses
Only
 PPPoE Protocol Only
Disable Yes
Set/Change Filter IP Address
Ranges
SU <start address> to <end
address>
or,
<base address> mask <mask>
0.0.0.0 TO 0.0.0.0
(all 8 entries)
No
DHCP Unicast Override Filter SU
 Disable DHCP Unicast
 Enable DHCP Unicast
Disable DHCP
Unicast
Yes
MIR: Downlink SU SU-3: 128-3072 (Kbps)
SU-6: 128-6016 (Kbps)
SU-54: 128-53888 (Kbps)
SU-I: 128-6016 (Kbps)
SU-3: 3072
SU-6: 6016
SU-54: 32896
SU-I: 6016
No
MIR: Uplink SU SU-3: 128-2048 (Kbps)
SU-6: 128-4096 (Kbps)
SU-54: 128-53888 (Kbps)
SU-I: 128-2048 (Kbps)
SU-3: 2048
SU-6: 4096
SU-54: 32896
SU-I: 2048
No
CIR: Downlink SU SU-3: 0-2048 (Kbps)
SU-6: 0-4096 (Kbps)
SU-54: 0-45056 (Kbps)
SU-I: 0-6016 (Kbps)
0 (Kbps No
CIR: Uplink SU SU-3: 0-2048 (Kbps)
SU-6: 0-4096 (Kbps)
SU-54: 0-45056 (Kbps)
SU-I: 0-2048 (Kbps)
0 (Kbps) No
Maximum Delay SU 300 – 10,000 (ms) 5,000 (ms) No
Maximum Burst Duration AU, SU 0 – 2,000 (ms) 5 (ms) No
Graceful Degradation Limit AU 0 – 70 (%) 70 (%) No
MIR Only Option AU
 Disable
 Enable
Enable No
VLAN Priority Threshold AU, SU 0 – 7 7 No
ToS Prioritization Option AU, SU
 Disable
 Enable IP Precedence
(RFC791) Prioritization
 Enable DSCP (RFC2474)
Prioritization
Disable No
IP Precedence Threshold AU, SU 0 – 7 4 No
DSCP Threshold AU, SU 0 – 63 32 No
UDP/TCP Port Ranges
Prioritization Option
AU, SU
 Disable
 Enable Only for UDP
 Enable Only for TCP
 Enable for both UDP and
TCP
Disable No
UDP RTP/RTCP
Prioritization
AU, SU
 RTP & RTCP
 RTP Only
RTP & RTCP No
TCP RTP/RTCP Prioritization AU, SU
 RTP & RTCP
 RTP Only
RTP & RTCP No