User's Manual

Parameters Summary
BreezeACCESS VL System Manual
267
Parameter Unit Range Default Run-Time
Spectrum Analysis
Channel Scan Period
AU, SU 2 – 30 seconds 5 seconds No
Spectrum Analysis Scan
Cycles
AU, SU 1 – 100 cycles 2 cycles No
Automatic Channel
Selection
AU
 Disable
 Enable
Disable No
(Configured
per
analysis)
Lost Beacons Watchdog
Threshold
AU 100 – 1000, 0 means Not
Used
218 Yes
Noise Immunity State
Control
AU, SU
 Automatic
 Manual
Automatic Yes
Noise Immunity Level AU, SU 0 – 4
Use only 0 or 4
0 Yes
Spur Immunity Level AU, SU 0 – 7 0 Yes
OFDM Weak Signal AU, SU 0 (not active) or 1 (active) 0 Yes
Pulse Detection
Sensitivity
AU, SU
 Low
 High
High Yes
* Not applicable if only one Sub-Band is available for the applicable Country Code
** Applicable only if DFS is supported by the Sub-Band
*** Configurable only in units without an integral antenna.
F.1.4 Network Management Parameters
Parameter Unit Range Default Run-Time
Access to Network
Management
AU, SU
 From Wireless Link Only
 From Ethernet Only
 From Both Ethernet and
Wireless Link
From Both Ethernet
and Wireless Link
No
Network Management
Filtering
AU, SU
 Disable
 Activate Management IP
Filter On Ethernet Port
 Activate Management IP
Filter On Wireless Port
 Activate Management IP
Filter On Both Ethernet
and Wireless Ports
Disable No
Set Network Management IP
Address
AU, SU IP address 0.0.0.0
(all 10 entries)
No
Set/Change Network
Management IP Address
Ranges
AU, SU <start address> to <end
address>
or,
<base address> mask <mask>
0.0.0.0 TO 0.0.0.0
(all 10 entries)
No
Send SNMP Traps AU, SU
 Disable
 Enable
Disable Yes
SNPM Traps IP Destination AU, SU IP address 0.0.0.0
(all 10 entries)
No