User's Manual

Appendix E - BreezeACCES VL MIB
BreezeACCESS VL System Manual
234
MIB Parameter Description Value/Range
*PowerLevelSteps
(*ATPC 6)
Applicable to AU/BU. The step in dB
that the SU/RB will use when
receiving an ATPC Power-
Up/Power-Down message
Integer
1-20 (dB)
*CellDistanceParameters
(*AirInterface 15)
Cell distance Parameters
*CellDistanceMode
(*CellDistanceParameters 1)
Applicable AU/BU. The selected
mode of deciding on Cell Distance.
Integer
automatic (1)
manual (2)
na (255)
*FairnessFactor
(*CellDistanceParameters 2)
Applicable AU/BU. Not applicable to
BreezeNET B products with SW
version below 4.0. The percentage
of the maximum distance that is
taken into account in the time slot
calculation.
Integer
Range: 0 to 100 (Percent). A
value of 0 means the
minimal slot size (9
microseconds).
Na (255)
*MeasuredMaxCellDistance
(*CellDistanceParameters 3)
Applicable AU/BU. The Maximum
Cell Distance as calculated by the
AU/BU.
Integer
Range: 0 to 54 (Kilometers).
1 means “below 2 km”.
*UnitWithMaxDistance
(*CellDistanceParameters 4)
Applicable AU only. Not applicable
to BreezeNET B units. The MAC
address of the unit with the
maximum distance from the AU.
MAC Address
*PerSuDistanceLearning
(*CellDistanceParameters 5)
Aplicable only to AU with SW
version 4.0 and higher. Applicable
only if Cell Distance Mode is set to
Automatic. When disabled, all SUs
in the cell will use for the ACK
Timeout the computed distance of
the farthest SU. When enabled,
each SU will use its own computed
distance.
Integer
disable (1)
enable (2)
*ScanningMode
(*AirInterface 16)
Applicable to SU/RB. The scanning
mode. In cells where the DFS Option
is enabled Scanning Mode is forced
to Passive.
Integer
passive (1)
active (2)
*Antenna Gain
(*AirInterface 17)
Applicable to all units. Read-write in
units where *AntennaGainChange
is supported. Read-only in units
where *AntennaGainChange is not
supported. The net gain (including
cable attenuation for detached
antennas) of the antenna.
Integer
0-50 (dB)
-1 (not configurable) means
“Not Set Yet”.
-2 (not configurable) means
“Don’t Care”.
*SpectrumAnalysisParameters
(*AirInterface 18)
Spectrum Analysis Parameters.
*SpectrumAnalysisChannelScanPeriod
(*SpectrumAnalysisParameters 1)
Applicable to all units. The period in
seconds of staying on each channel
for information gathering during each
cycle when performing Spectrum
analysis.
Integer
Range: 2-30 seconds.
*SpectrumAnalysisChannelScanCycles
(*SpectrumAnalysisParameters 2)
Applicable to all units. The number
of scanning cycles when performing
Spectrum Analysis.
Integer
Range: 1-100 seconds.
*AutomaticChannelSelection
(*SpectrumAnalysisParameters 3)
Applicable to AU/BU. Defines
weather the AU/BU shall choose the
most noise free channel upon
startup after spectrum analysis.
Integer
disable (1),
enable (2),
na (255)
*SpectrumAnalysisActivation
(*SpectrumAnalysisParameters 4)
Applicable to all units.
Activates the spectrum analysis. The
Integer
cancelOperation (1),