User's Manual

breezeAccessVLMib
BreezeACCESS VL System Manual
231
MIB Parameter Description Value/Range
higher. The ID of the sub-band used
by the unit.
*DFSParameters
(*FrequencyDefinition 11)
DFS Parameters. Applicable to
AU/BU.
*DFSOption
(*DFSParameters 1)
Applicable to AU/BU.
Enabling/disabling the DFS
Algorithm. Not applicable if DFS
Option is not supported by the
current Sub-Band.
Integer
disable (1)
enable (2)
na (255)
*DFSChannelCheckTime
(*DFSParameters 3)
Applicable to AU/BU.
Defines the time the unit checks the
channel for presence of radar
signals and does not transmit after
power up or association
or after moving to a new channel
due to detecting radar in the
previously used channel.
Integer
Range: 1 to 3600 (seconds).
*DFSChannelAvoidancePeriod
(*DFSParameters 4)
Applicable to AU/BU.
Defines the time after detecting
radar signals in a channel of
avoiding using the channel or
adjacent channels in accordance
with the bandwidth.
Integer
Range: 1 to 60 (minutes).
*DFSSuWaitingOption
(*DFSParameters 5)
Applicable to AU/BU.
Defines whether the associated SUs
may should wait for this AU/BU after
it stopped transmitting due to radar
detection, before they starts
scanning for other AUs/BUs.
Integer
disable (1)
enable (2)
na (255)
*DFSClearRadarChannels
(*DFSParameters 6)
Applicable to AU/BU.
Clear Radar Detected and Adjacent
to Radar channels after unit reset.
Returns the unit to operate in default
frequency
Integer
cancel (1)
clearRadarChannels (2)
na (255)
*DFSRadarDetectionChannelsTable
(*DFSParameters 7)
Applicable to AU/BU.
Applicable only when DFS option is
on. Displays the current channels
defined in the sub-band and their
radar detection status.
*DFSRadarDetectionChannelsEntry
(*DFSRadarDetectionChannelsTable 1)
Applicable to AU/BU.
An entry in the DFS Radar Detection
Channels Table.
*DFSChannelIdx
(*DFSRadarDetectionChannelsEntry 1)
Applicable to AU/BU. Read-only.
The index of the entry in the DFS
Radar Detection Channels Table.
Integer
*DFSChannelFrequency
(*DFSRadarDetectionChannelsEntry 2)
Applicable to AU/BU with HW
revision B and lower (for units with
HW revision C and higher replaced
by * DFSChannelFrequency New to
support a resolution of 0.5 MHz).
Read-only. The frequency in MHz of
a channel in the DFS Radar
Detection Channels Table.
Integer
*DFSChannelRadarStatus
(*DFSRadarDetectionChannelsEntry 3)
Applicable to AU/BU.
The radar detection status of a
channel in the DFS Radar Detection
Channels Table.
Integer
radarFree (1)
adjacentToRadar (2)
radarDetected (3)
*DFSChannelFrequencyNew
(*DFSRadarDetectionChannelsEntry 4)
Applicable to AU/BU. Read-only.
The frequency of a channel in the
DFS Radar Detection Channels
DisplayString