User's Manual

breezeAccessVLMib
BreezeACCESS VL System Manual
229
MIB Parameter Description Value/Range
read-only parameter.
The scanning step to be used for
generating the frequency subset.
mhz-20 (3)
na (255)
*FrequencySubsetTable
(*FrequencyDefinition 4)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Not accessible. The
Frequency Subset table that
includes all frequencies from the
selected Sub-band.
*FrequencySubsetEntry
(FrequencySubsetTable 1)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Not accessible. An entry in
the Frequency Subset table.
*FrequencySubsetTableIdx
(*FrequencySubsetEntry 1)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Read-only. The index of an
entry in the Frequency Subset table.
Integer
*FrequencySubsetFrequency
(*FrequencySubsetEntry 2)
Applicable to all units with HW
revision B and lower (for units with
HW revision C and higher replaced
by *FrequencySubsetFrequencyNew
to support a resolution of 0.5 MHz).
Not applicable to SU/RB with SW
version 4.0 and higher. Read-only.
The frequency in MHz of an entry in
the Frequency Subset table.
Integer
*FrequencySubsetActive
(*FrequencySubsetEntry 3)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. The status of an entry in the
Frequency subset Table. Only
frequencies of active entries will be
included in the final list of
frequencies to be used for scanning.
Integer
active (1)
notActive (2)
*FrequencySubsetFrequencyNew
(*FrequencySubsetEntry 4)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Read-only. The frequency in
MHz of an entry in the Frequency
Subset table. (Replaces
*FrequencySubsetFrequency to
support a resolution of 0.5 MHz for
units with HW revision C and
higher).
DisplayString
*SetSelectedFreqsSubset
(*FrequencyDefinition 5)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Apply the selected subset.
After the next reset the new subset
will be used for scanning.
Integer
SetSelectedFreqsSubset (1)
cancel (2)
*CurrentFrequencySubsetTable
(*FrequencyDefinition 6)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Not accessible. The Current
Frequency Subset table that for
SU/RB includes all frequencies that
are currently used for scanning. In
AU/BU it includes all frequencies
that can be used by the DFS
mechanism (if applicable).
*CurrentFrequencySubsetEntry
(CurrentFrequencySubsetTable 1)
Applicable to all units. Not applicable
to SU/RB with SW version 4.0 and
higher. Not accessible. An entry in
the Current Frequency Subset table.