User's Manual

Chapter 4 - Operation and Administration
BreezeACCESS VL System Manual
92
 Set Partial Factory Defaults
 Set Complete Operator Defaults
 Set Partial Operator Defaults
 Cancel Current Pending Request
4.2.3.2.1.1 Set Complete Factory Defaults
Select this option to reset the unit to the standard Factory Defaults configuration,
excluding several parameters that are listed in Table 4-2.
Table 4-2: Parameters not reset after Set Complete Factory/Operator Defaults
Parameters Group Parameter
All Passwords
FTP Server IP address* (see note below)
FTP Gateway IP address* (see note below)
FTP User Name* (see note below)
FTP Password* (see note below)
Unit Control Parameters
Ethernet Port Negotiation Mode
Selected Sub-Band (AU)
Frequency (AU)
DFS Option (AU)
Frequency Subset (AU)
Air Interface Parameters
Antenna Gain (AU)
NOTE
The FTP parameters are not set to their default values after Set Complete Operator Defaults.
However, they are set to their default value after Set Complete Factory Defaults. Note that in this
case they are set to the default values immediately upon selecting the Set Complete Factory
Default option (even before the next reset).
4.2.3.2.1.2 Set Partial Factory Defaults
Select this option to reset the unit to the standard Factory Default configuration,
excluding the parameters that are required to maintain connectivity and
management access. The parameters that do not change after Set Partial Factory
Defaults are listed in Table 4-3.