User's Manual

Menus and Parameters
Manual Revision 1.0
4-15
Table 4-3: Parameters that are not reset after Set Partial Factory/Operator Defaults
Parameters Group Parameter
VLAN ID – Management Bridge Parameters
MAC Address Deny List (AU)
Set Complete Operators Defaults
Select this option to reset the unit to the Operator Defaults
configuration, excluding several parameters that are listed in Table 4-2.
Set Partial Operator defaults
Select this option to reset the unit to the Operator Defaults
configuration, excluding the parameters that are required to maintain
connectivity and management access. The parameters that do not
change after Set Partial Operator Defaults are listed in Table 4-3.
Cancel Current Pending Request
Once you selected one of the Set defaults options, it will be executed
after the next reset. This option enables you to regret and cancel the
pending request before execution (provided the unit has not been reset
yet).
Save Current Configuration As Operator Defaults
The Save Current Configuration As Operator Defaults enables defining
the current configuration of the unit as the Operator Defaults
configuration.
Change Unit Name
The Change Unit Name option enables changing the name of the unit,
which is also the system's name in the MIB2. The name of the unit is
also used as the prompt at the bottom of each Monitor window.
Valid values: A string of up to 32 printable ASCII characters.
The default unit name is an empty string.
Change Password
The Change Password submenu enables changing the access
password(s). The Change Password submenu is available only to users
with Administrator access rights.